Wasp-barcode WDI4600 2D Product Reference Guide Bedienungsanleitung PDF herunterladen (Seite 54)

Enter/Exit Programming Mode Data Format

WDI4600

Global Prefix/Suffix

This option sets up to 20 characters each from the set of ASCII characters or any hex value from

00 to FF. The characters may be added as a prefix (in a position before the barcode data, also

called a header) and/or as a suffix (in a position following the barcode data, also called a footer).

See page 219 for more detailed instructions on setting th

is feature.

To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE barcode above

to place the unit in Pr

ogramming Mode, then the “Set Global Prefix” or “Set Global Suffix,”

barcode followed by the digits (in hex) from the Alphanumeric characters in Appendix D,

Keypad representing your desired character(s). If l

ess than the expected string of 20 characters

are selected, scan the ENTER/EXIT barcode to terminate the string. Exit programming mode

by s

canning the ENTER/EXIT barcode again.

$CLFPR

Set Global Prefix

$CLFSU

Set Global Suffix

Make a mistake? Scan the CANCEL barcode to abort and not

save the entry string. You can then start again at the begin-

ning.

CANCEL

DEFAULT

No Global Prefix

Global Suffix = 0x0D (CR)

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 283 284

Keine Kommentare

Wasp-barcode WDI4600 2D Product Reference Guide Bedienungsanleitung Seite 54