Wasp-barcode WDI4600 2D Product Reference Guide Bedienungsanleitung PDF herunterladen (Seite 226)

References

216

WDI4600

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable range

for this feature is from 0 to 99 seconds.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 =

20, etc

Go to page 37 and scan the ENTER/EXIT PROGRAMMING MODE barcode to enter

Programming Mode.

4. Scan the barcode: SELECT INTERCODE DELAY SETTING.

5. Scan the appropriate two digits from the keypad in Appendix D, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the begin-

ning.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 34 for some examples of how to set this feature.

Table 34. Wedge Intercode Delay Examples

STEP ACTION EXAMPLES

1 Desired Setting

No Delay 5 Seconds 60 Seconds 99 Seconds

2 Pad with leading zero(es)

00 05 60 99

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT INTERCODE DELAY SETTING

Scan Two Characters From

Appendix D, Keypad

‘0’ and ‘0’ ‘0’ and ‘5’ ‘6’ and ‘0’ ‘9’ AND ‘9’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 283 284

Keine Kommentare

Wasp-barcode WDI4600 2D Product Reference Guide Bedienungsanleitung Seite 226